Oh R50/R52/R53 centre console magnet phone mounts by Tom Alcock
These use the existing holes/screws that hold the down tubes for the center console – no extra holes/screws required.
To install simply open the glovebox, remove the two torx screws holding the down tube in place, position the phone mount in place and reinsert the torx screws.
1 x Phone Mount
2 x Metal phone sticky pads
2 x Phone sticky pad protectors
It’s recommended to use both metal pads on top each other if you have a larger/heavier phone, these are all included for you to find the best setup that works for you.
You can also fix any other screw in mount to these, such as Brodit mounts (see picture). These are available on Amazon and specifically designed to fit your phone.
New V2 design consists of a new 8 magnet design vs the V1 1-2 magnet design, rubber has also been added to the mount to stop any potential spinning.
This means much stronger magnetism between the mount and your phone.
PLEASE NOTE THESE ARE MADE TO ORDER SO ALLOW A FEW DAYS FOR DISPATCH 🙂